Legion Solar Installation and Operations Manual
Grid Connection Method2: Hardwire
Copyright © 2021 PLX Devices Inc.
19
Step1:
Ensure the T-Harness and the Straight-Harness
are NOT connected.
Step2:
Cut the male side of the Straight-Harness
Step3:
Obtain the following parts from your local
hardware store in the electrical section.
1. Outlet box Three hole 1/2 in. All-weather
2. Outlet box blank cover. All-weather
3. UF Cable Connector 1/2 in.
4. Cord Grip Connector 1/2 in.
5. Wing nut wire connectors
6. Outdoor cable type UF-B two conductor with
ground. See table below for gauge selection
Step4:
Install the Cord Grip Connector 1/2 in. Cut the
black insulation sheeting, and strip the 3 wires
from the Straight-Harness like the photo
Step5:
Check your outdoor cable and ensure that the
electricity is OFF.
WARNING! An electrical condition, if not
avoided, could result in death, serious injury,
fi
re, equipment or property damage. Use
extreme caution and follow instructions
carefully.
