4
- Programming (code matching and code clearing) and group division
·Select
down lights
which need to be group controlled, switch off the
power supply at the wall switch for 10 seconds and switch on again, at
the moment it’s switched on (within 3 seconds), press the upper side of
the button on remote
“CH1,CH2,CH3 or CH4
”
you want to use ,the
light will “flash slowly for three times” to confirm it is matched.
·Repeat above steps until all the down lights are grouped on different
channels.
2.4 Group control with remote controller
After finishing code matching and grouping between the
down lights
and
controllers, these actions can be done wirelessly:
·Press button “ON”
, all the down lights will be switched ON.
·As above, press “The Middle Panel Button”
, to adjust the lamp
brightness in one colour temperature and change colour from warm
white to cool white. Up/ Down button for brightness in one colour
temperature, Left/ Right button for different colour temperature
conversion.
·To adjust brightness to the maximum level press and hold “ON”
.
·Press “OFF”
to turn off all
down lights
at the same time.
·Press and hold “CH1,CH2,CH3 or CH4”
, all lights in this
group will be adjusted to the brightest state at the same time.
Summary of Contents for AU08-DL13W/W/S
Page 2: ...2 1 Product Image ...
