OPERATING INSTRUCTIONS.
Read the entire SAFETY INFORMATION section at the beginning of this manual
including all text under subheadings therein before using this product.
Use this tool for the manufacture’s intended purpose only. Use other than that which is
described in this manual can result injury or property damage.
HOW TO ASSEMBLE THE PUNCH AND HOLDER:
1.
Select the appropriate punch die set. Ask an authorized facility or distributor to
choose proper punch and die set for hole punching.
Do not exceed the rated capacity of this tool, otherwise it will
caused a component failure, which could throw broken parts
with great force. Failure to observe this warning can
result injury or death.
2.
Insert the punch into the upper shoulder; use the nut to lock it by hex spanner.
3.
Insert the die into the lower shoulder, use a hex spanner to screw the nut to lock the
die.
4.
Put up the active handle, place the plate between the punch and die
An improper setup could cause the components damage.
5.
Press the active handle lever completely punching at a time, the scrap come out
6.
after punching, keep the active handle locked by hook..
Do not punch on hard metal plate ot punch over the max
thickness.
Do not allow anyone to stand round of the tool. Ignore this warning can result in
injury or damage.
SPECIFIC SAFETY RULES
1.
Maintain labels and nameplates on the tool which carry important safety information.
If unreadable or missing,
contact the agent to replace.
2.
This product is not a toy, keep it out of reach of children.
3.
Do not slide your fingers in the punch & dies profile.
4.
Do not put your fingers in the head of the tool when you slide the dies inside it. Your
fingers could be pinched very severely.
5.
Do not use the tool without punch & die.
6.
Do not use this tool near live circuits.
7.
The warnings, precautions, and instructions discussed in this instruction manual
cannot cover all possible conditions and situations that may occur. It must be
understood by the operator that common sense and caution are factors which cannot
be built into this product, but must be supplied by the operator
.
SAVE THIS INSTRUCTIONS
plumBOSS Australia Ph: 1300 331 141 | E: [email protected] | www.plumboss.com.au