Plinius SA-50 instruction manual. Page 14
CHANGING THE MAINS / LINE VOLTAGE CONFIGURATION
In the event that your Mains / Line voltage is different to that printed on the back of the SA-50, it may
altered by a suitably qualified or experienced person.
There are only two options,
110V - 120V
or
220V - 240V
Operation
Firstly disconnect the lead from the IEC socket on the SA-50 and make sure the MAINS switch is OFF.
Turn the SA-50 over so the base is facing up.
Carefully remove the 12 cross-head screws, and the 2 large flat screws.
This will allow the base to come free.
Locate the terminal block with a clear perspex guard, remove the guard by undoing the M3 nuts.
The ring terminals can be moved by undoing the cross-head screws.
Use the layout label stuck to the base of the SA-50 to ensure correct orientation of the wires.
DOUBLE CHECK THE WIRE ORIENTATION BEFORE RE-ASSEMBLING THE SA-50.
Re-assemble the SA-50 and verify correct operation, by attempting correct operation.
If there are any resultant problems consult your Plinius Dealer.
Plinius SA-50 instruction manual. Page 15
CONNECTIONS FOR STEREO OPERATION.
Connect the input and output cables to the amplifier. The use of high quality cables and connectors is
highly recommended.
DO NOT Operate this amplifier with both RCA and XLR cables connected at the same time.
INPUTS
