16
PLINIUS MAURI
Troubleshooting
NO SOUND FROM THE UNIT
If the unit is not reproducing audio take the following steps:
•
Check the Mauri is correctly connected to an appropriate input on the
preamplifier. Refer to the Installation & Operation section.
•
Check the preamplifier is set to select the correct source input. Adjust the source
selector for the Mauri as the source component.
•
Check the volume. Turn the volume up to a point just below the normal listening
level. DO NOT turn the volume up to maximum in case the sound begins to come
through the speakers.
•
Check the system is working with another source to confirm the fault is not due
to the preamplifier or power amplifier stages.
NO TRACK DISPLAY LEDS
•
Check a valid CD is in the transport. If the CD cannot be read, the Mauri will not
show any track information.
•
Adjust the display brightness through the levels high, low and off in case the
display has gone into standby mode.
POWER FAILURE
The unit may have suffered mains fuse failure. Check the mains fuse and replace if
needed. NOTE: If the unit immediately or repeatedly suffers mains fuse failure, there
may be a major problem and you should contact your Plinius dealer.