Page 12
9
Snap the camera/plate combination into the plate adaptor that is already
attached to the mounting bracket. Note that there is only one possible
orientation. The large lever will snap closed. Move the small brass lever to the
lock position. Make sure that the large lever cannot be unlocked.
10
Connect the FireWire cable(s) to the camera(s). Use the FireWire socket
labeled “1” in the photo.
11
Connect the other end(s) of the camera FireWire cable(s) to any port(s) in the
FireWire board in the computer. Tighten the screws so that each plug is
secure in its socket.
12
Connect the camera trigger cable(s) to the trigger cable socket on the
camera(s).
13
Connect the other end(s) of the camera trigger cable(s) to any of the ports on
the ACCES I/O Adaptor on the computer (shown in the image below).
CAUTION
Never plug or unplug a camera FireWire cable with the PC Power ON.
Permanent damage to the camera may result. Please note that any
damage due to this cause is not covered by the Plexon warranty.
1
2
Trigger cable
socket
FireWire
socket 1