Programming Collar Keys:
Your Plexidor
®
Electronic Pet Door will arrive with 2 collar keys that have been programmed to match
the pet door. If you need to order more collar keys or replacement collar keys you will program them
as follows below. You may program as many collar keys as you need. To program collar key(s):
1. Remove the motor cover by squeezing from both sides and tipping the motor cover down and
out. Once the motor cover is removed you will see the metal spring, motor and green circuit board
of the control panel.
The Program Button, Test Button and green LED Program Light are marked on the green board.
See diagram #5.
2. Take the collar key that you wish to program and bring it in front of the antenna loop area of the
pet door. See diagram #2. Hold the collar key in this area until you see the blue ON/OFF light
flash.
3. Push and hold the Program Button for approximately 4 seconds, until the Program Light flashes
green and you hear a quick beep. The collar key is now programmed.
4. Check to make sure the key is properly programmed by holding the collar key in the antenna
sensing area. The door should open. If the door does not open, check that the blue ON/OFF light
is on and blinking approximately every 1.5 seconds. This is to ensure that the pet door is receiving
power. If the blue ON/OFF light is on and blinking, then repeat steps 1 through 3 above.
When the blue ON/OFF light is rapidly blinking the door is sensing a collar key that has not been
programmed.
Plexidor
®
Electronic Owners Manual Pg 6
Version 20100427
Training Your Pet to Use the Plexidor
®
Electronic Pet Door:
Your pet needs to realize that they can go in and out of the pet door. Some pets will get the idea right
away when they approach the door with the collar key on and they see the pet door opening.
If further training is needed, you can keep the pet door in the open position and then coax your pet
through with a treat. Do this several times to get your pet used to going in and out.
Never
force your
pet through the pet door. To keep the pet door in the open position you hold the collar key in front of
the pet door until it opens. When the panel reaches the fully open position pull out the power plug.
After your pet has gone through a few times return the pet door to its normal closed position. To do
this simply plug it back in and it will reset itself. Then call your pet from the other side of the pet door
and when your pet comes through give them a treat. Do this a few times. That should be all the
training required.
If your pet is not getting close enough to make the door open, use the brown training stickers pro-
vided with the template. Put a sticker “button” on both sides of the sliding panel. Then teach the
dog to touch the button with their nose.
IMPORTANT: Never force your pet through the pet door.
