CAP-2000
DT Istr (CAP-2000) 05/14_ Rev 2_05/17
13/16
INSTALLATION
IF YOU WANT TO USE THE HEATER ON WHEEL
Lay carefully the appliance and
apply the wheels at the bottom of
the foot as shown in figure 1.
Warning: PLACED NOT CAREFUL, MAY DAMAGE THE GLASS!
IF YOU WANT TO USE THE HEATER
WALL-HUNG
1.
Before you assemble your fireplace, you should
remove the hanger.
2.
Put the fireplace on flat and soft floor.
3.
Use screwdriver (not supplied) to loosen the 2
screws and remove the hanger as shown in
figure 2 .
4.
Referring to Fig. 3, select a suitable
position in which to mount the heater
horizontally – use a spirit level to
achieve this.
5.
Referring to Fig. 4 , check the wall to
ensure there is no wiring, pipe wires etc
in the area to be drilled. Drill 4 holes
(8mm diameter & 40mm depth) using a
suitable size drill, put the wall plugs into
the holes and fix hanger to wall.
6.
Reffering to figure 5, hang heater to hanger.
7.
Reffering to figure 6, avoid fireplace to move, use screw fix fireplace to wall
This heater is for wall mounting only. Do not attempt to use it free standing.
Warning! Always ensure the fireplace is at least 20cm above the floor and be sure that the bolts have been
fixed firmly enough to withstand the weight
！
FIG. 1
FIG.2
445
8mm
335
FIG. 4
FIG. 3
