PleasureCraft Engine Group crusader, Owner'S Operation And Maintenance Manual, Page: 78 / 96

76
L510001-05
OUT-OF-SEASON STORAGE - 13
CAUTION
If the engine(s) is (are) to be started prior to
launching, use the procedure FLUSHING COOLING
SYSTEM before proceeding to start the engine(s).
14. Open the seacock before starting the engine.
15. Start the engine and closely observe the
instrument panel. Allow the engine to reach
normal operating temperature. Inspect the
engine carefully for fuel, exhaust, oil and
water leaks.
16. Check the steering, shift and throttle controls
for proper operation.
8. Before starting the engine, be sure there is
not an excess amount of storage oil left
in the cylinders. Remove the spark plugs.
Disable the fuel pumps and ignition high
voltage spark by removing the MEFI System
Relay. Using rags draped over the exhaust
manifolds or some other suitable material or
method, create a defl ector or catcher for the
oil that will be sprayed from the spark plug
holes. Turn the ignition switch to the start
position and rotate the engine three (3) or four
(4) times.
9. Reinstall the MEFI System Relay.
10. Install the spark plugs and connect the spark
plug wires.
11. Open the fuel shut-off valve (if equipped).
12. Refer to the OPERATING INSTRUCTIONS
section and perform all the safety checks
before starting the engine.
13. Refer to the Engine Maintenance section
and perform the Priming the Fuel System
instructions.
CAUTION
Failure to remove the excess storage oil from the
engine’s cylinders can cause hydrostatic locking to
occur, and severe damage to the engine.
RECOMMISSIONING AFTER STORAGE