12
OPERATING INSTRUCTIONS
LEAK CHECK
1. Make 2-3 oz of leak check solution (one part liquid
dishwashing detergent and three parts water)
2. Put leak solution in a spray bottle.
3. Make sure control knob is set to O (OFF).
4. Connect the LP tank to the regulator. Apply several
drops of solution where the tank connects to the
regulator and where corrugated pipe attaches to
regulator and control valve. See if bubbles appear.
(Figure 1)
WARNING:
DO NOT ROTATE THE CONTROL KNOB
DURING THE LEAK CHECK.
1
WARNING
ALL INSTRUCTIONS AND SAFEGUARDS ON THIS PAGE MUST BE FOLLOWED TO
PREVENT FIRE, DAMAGE AND/OR INJURY.
CAUTION: Only use the regulator provided.
If a replacement is necessary, please call our
customer service center. Do not use replacement parts that are not intended for this fire pit.
How to install LP tank:
Remove the door panel (I). Turn the regulator outwards and screw the LP tank clockwise into the
regulator.
WARNING:
Hand tighten only. Using excessive force could damage the regulator coupling and could
cause a leak. The cylinder must be fully upright for the cylinder to have vapor withdrawal only.
• Perform all leak tests outdoors.
• Extinguish all open flames.
• NEVER leak test when smoking.
• Do not use the fire pit until all connections have been leak tested and do not leak.
WARNING
NEVER USE A LIGHTER/FLAME TO CHECK FOR GAS LEAKS.
DANGER
