TO INSERT BATTERIES
Using a Phillips/cross head
screwdriver, loosen the screw in
the battery compartment cover
(screw stays attached to cover).
Remove cover. Insert 3 x 1.5V
“AA” or LR6 size alkaline batteries
(not included). Replace cover and
tighten screw.
CAUTION: TO AVOID BATTERY LEAKAGE
1. Be sure to insert the batteries correctly and always follow the toy
and battery manufacturers’ instructions;
2. Do not mix old and new batteries or alkaline, standard (carbon-
zinc) or rechargeable (nickel-cadmium) batteries;
3. Always remove weak or dead batteries from the product.
IMPORTANT: BATTERY INFORMATION
Please retain this information for future reference.
Batteries should be replaced by an adult.
CAUTION:
1. Always follow the instructions carefully. Use only batteries
specified and be sure to insert item correctly by matching the +
and – polarity markings.
2. Do not mix old batteries and new batteries or standard (carbon-
zinc) with alkaline batteries.
3. Remove exhausted or dead batteries from the product.
4. Remove batteries if product is not to be played with for a long
time.
5. Do not short circuit the supply terminals.
6. Should this product cause, or be affected by, local electrical
interference, move it away from other electrical equipment. Reset
(switching off and back on again or removing and re-inserting
batteries) if necessary.
7. RECHARGEABLE BATTERIES: Do not mix these with any other types
of battery. Always remove from the product before recharging.
Recharge batteries under adult supervision. DO NOT RECHARGE
OTHER TYPES OF BATTERIES.
