End of Pigtail faces OUT
GLIDER SWING BRACKET INSTALLATION
NOTE: THE GLIDER BRACKET DOES NOT COME WITH HEX LAG SCREWS AND WASHERS.
Assemble the Glider Brackets as shown in Detail A below.
Measure from the protective surfacing under your swing beam to the bottom of the swing beam. Use
the chart below to find "Dimension A" that matches the measurement you just made.
1. Place the Glider Bracket over the top of the beam. Keep in mind when placing these brackets
that the outside of the Chill 'N Swing must be located 8" away from any other swing or swing structure.
2. Fasten the top hole in the bracket to the beam with a 3/8" x 2-1/2" hex lag screw and a 3/8"
washer.
3. Predrill 11/64" holes 1-1/2" deep into the beam through the holes in the flanges of the bracket.
4: Attach the flanges to the beam with 3/8" x 1-1/2" hex lag screws and 3/8" washers.
5: Space the second Glider Bracket away from the first bracket by the distance "A". Repeat 2-4.
28mm x 11mm W
Spacer
bushing inside
Pigtail hook with
SCALE 1 : 4
DETAIL A
Shoulder Bolt
10mm x 58mm
10mm
Lock Nut
A
3/8" WASHER
HEX LAG SCREW
3/8 X 1-1/2"
BRACKET
GLIDER
MEASURE HEIGHT
FROM BOTTOM OF
BEAM TO PROTECTIVE
SURFACING ON THE
GROUND. MATCH THIS
MEASUREMENT TO THE
CHART TO DETERMINE
"Dimension A".
Dimension A
3/8 X 2-1/2"
HEX LAG SCREW
Dimension
A
Height
from
surfacing
to
bottom
21
81
21
82
21
1/16
83
21
2/16
84
21
2/16
85
21
3/16
86
21
4/16
87
21
4/16
88
21
5/16
89
21
6/16
90
21
6/16
91
21
7/16
92
21
8/16
93
21
8/16
94
21
9/16
95
21
9/16
96
21
10/16
97
21
11/16
98
3
