• You can play alone (single player), or compete
against friends. To choose the number of players,
press the button. To get back to one player
(default), hold down the button to reset.
• In a single player game, the final time will be
displayed on the screen after hitting all five targets.
• In a multiple player game, each player’s final time
will stay on the screen until the next player presses
the trigger to clear the screen, then again to start
their game!
• After each player’s turn, you will see a light show.
At the end of a multiple player game, all players’
times will flash on the screen so you can see
who won!
Choose your game length time and then see how
many targets you can hit in that time! *
• Press the game selection button 2.
• To set your timer for this game, press button 2
until you see the time you want. It starts with 20
seconds and increases in 10-second increments
when you press button 2. To clear the time just
hold down button 2 to reset to 20 seconds.
• Press the
trigger
when you
are ready to start the game!
Note:
Once the game has
started, you cannot add any more players.
• Do not mix alkaline, standard (carbon-zinc), or rechargeable batteries.
• Do not mix old and new batteries.
• Only batteries of the same or equivalent type as recommended are to be used.
• Batteries are to be inserted with the correct polarity.
• Exhausted batteries are to be removed from the toy.
• The supply terminals are not be short-circuited.
• Dispose of batteries safely.
• Batteries may explode or leak if disposed of in a fire.
• Remove batteries from a product if it will not be used for a month or longer.
• Follow applicable laws and local regulations for the disposal
and transportation of batteries.
*FCC INFORMATION
NOTE:
This equipment has been tested and found to comply with the limits for Class
B digital device, pursuant to part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of
the following measures: -- Reorient or relocate the receiving antenna. --Increase the
separation between the equipment and the receiver. --Connect the equipment into an
outlet on a circuit different from that to which the receiver is connected. --Consult the
dealer or an experienced radio/TV technician for help.
Please note that changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
In exceptional circumstances batteries may leak fluids that can cause a chemical burn
injury or ruin your toy. To avoid battery leakage:
• Adult supervision is recommended when changing batteries.
• Non-rechargeable batteries are not to be recharged.
• Rechargeable batteries are to be removed from the toy before being charged.
• Rechargeable batteries are only to be charged under adult supervision.
Really Quick –
How Do You Play?
Set the five targets out around the
room to create your “game course.”
Hold the tagger and when it lights
up a color, race to that color target
and insert it to “strike” your target!
The tagger will then flash a new
color, and so on!
Really Quick –
How Do You Play?
1
Tagger
5
Targets
1 or More Players | Ages 6 & Up
Contents:
Game Selection Buttons 1, 2 and 3
Game Mode
Indicator
Yay or Nay
Note:
Your tagger will turn off after five minutes
of inactivity. If you need to restart your part of the
game, just move the switch to “O” symbol and back
to the “I” symbol.
We wanna hear about all the fun you had!
Contact us at: Customer Service, 1400 E. Inman Pkwy., Beloit, WI 53511
[email protected] • 1-800-524-4263.
For more fun, visit
playmonster.com
C
opyright © 2017 PlayMonster LLC, 1400 E. Inman Pkwy., Beloit, WI 53511 USA.
Made in China. All rights reserved.
Ultra Dash
and
Move Fast When the Colors Flash!
are trademarks of PlayMonster LLC
.
Invented and licensed by Kid Group, LLC. 7015
Battery Safety Information
Battery Safety Information
Yay or Nay
GAME 2 : TARGET TALLY
GAME 2 : TARGET TALLY
GAME MODES
GAME MODES
Instructions :
Instructions :
Place your targets
sporadically throughout
the room.
To power up your tagger, just
move the switch to “I.” You’ll hear a
fun sound and see a light show that
tells you your tagger is on!
Set Up – Get Ready!
Set Up – Get Ready!
Use the game selection buttons 1, 2 and 3 to
choose which mode you will play in.
1
2
3
Race to hit all five targets as fast as you can! (This is
the default mode when you turn on your tagger. But, to
switch back to it, press the Game Selection Button 1.)
GAME 1 : BEAT THE CLOCK
GAME 1 : BEAT THE CLOCK
1
2
3
Randomizer Button
Your tagger will make lots of fun sounds while you
play, and some of those will tell you if you hit your
correct targets. For example, if you hit the yellow
target when the tagger is lit up green, you’ll get a
“wrong” sound…oops! When you hit the correct
color, you’ll get a “correct” sound…hurray!
When you hit your last target correctly, your tagger
will celebrate with fun sounds and a light show!
1
2
3
Time
Indicator
Button 2
• You can play alone (single player), or compete
against friends. To choose the number of players,
press the player button. To get back to one
player (default), hold down the button to reset.
• In a multiple player game, each player’s final score will
stay on the screen until the next player presses the trigger
to clear the screen, then again to start their game!
• After each player’s turn, you will see a light
show. At the end of a multiple player game, all
players’ times will flash on the screen so you
can see who won!
Team vs. Team!
Choose the number of players per team and then
take turns passing off the tagger and racing to hit
five targets each!
• Press the game selection button 3. Players
separate into two teams with even numbers.
• To choose the number of players, press the
player button until you see the number you
want. To reset the number of players, hold
down the player button.
• When the game starts, player 1 races to the
first five targets and then passes the tagger off
to player 2, and so on.
• The team’s final time will be displayed on the
screen until the next team presses the trigger to
clear the screen, then again to start their game.
• After each team’s turn, you will see a light
show and hear a sound. At the end of the
game, each team’s time will flash on the
screen so you can see who won!
GAME 3 : RELAY RACE
GAME 3 : RELAY RACE
How to Switch it Up!
How to Switch it Up!
Contents:
* The Tagger can only record up to 99 Targets.
Helpful Hint:
When you
strike a target, be sure to
place the tagger all the way
into the target so it registers
the hit.
Move your targets around for a
different “game course” each
time! And, to change the order
of the lights during a game,
press down the randomizer
button before you start a
new game. Turn your tagger on
and off using the bottom switch.
Battery Installation
Battery Installation
Try Me
Mode
Installing/Replacing
the Batteries
This unit requires 3 AAA batteries
(included)
Note:
Batteries should always
be installed by an adult.
Use a Phillips screwdriver to open the
battery compartment door located on
the bottom of the unit.
Insert 3 AAA batteries into the unit with + and
– terminals as indicated in the the illustration to the right.
Replace the compartment door and tighten up the screw with
a Phillips head screwdriver. Do not over-tighten the screw.
On
Mode
Off
Mode
Keep these instructions for future reference as they contain
important information.
Keep these instructions for future reference as they contain
important information.
UltradashRules_Revised.indd 1
6/8/17 1:56 PM