©2021
Installation
Surface Mount
Arc
Rack
RECOMMENDED BASE MATERIAL
Solid concrete is the best base material for installation. To ensure the proper anchors
are shipped with your rack, ask your Dero Rack representative which anchor is
appropriate for your application. Be sure nothing is underneath the base material that
could be damaged by drilling.
TOOLS NEEDED
Tape Measure
Marker or Pencil
Masonry Drill Bit 3/8”
Drill (Hammer drill recommended)
Hammer
Wrench 9/16”
Level
Drill 3/8” diameter holes 3” deep into surface. Make sure the
holes are at least 3” away from any cracks in the base material.
Thread nuts onto anchors, leaving approximately 1/4” of the
anchor protruding, and tap into surface. Tighten nuts down to
secure rack.
Place the rack in the desired location. Use a marker or pencil to
outline the holes of the flange onto the base material.
Place rack (and washers to level rack if necessary) over holes.
1
3
2
4
Ø 3/8”
9/16”
3”
