MPD-8 User Manual
13
CHANGING THE FUSE ON THE MPD-8
Inside the power connector on the rear panel of the MPD-8 are two fuses that protect the machine from
dangerous power surges. If the machine fails to power up or no light on the front panel is lit after pressing the
standby power button on the front panel then proceed as follows to change the fuses:
1. Locate fuse compartment on power connector on rear panel:
2. Use a small flat screw driver to pry open the fuse compartment as shown in above picture.
3. Pull fuse compartment out and flip sideways as shown below:
4. Replace both fuses with 1.6A / 250V slow blow types. Length is 20mm
CLEANING THE CHASSIS OF THE MPD-8
It is possible that the chassis can stain slightly from finger prints or you may discover subtle stains on the
surface that can be caused by the packaging material during shipping. You can easily clean the chassis with
either window cleaning solution and a clean and soft cloth. The best way is with a micro fiber cloth that you
spray slightly with WD-40. Do not spray it directly on the chassis, but rather on the cloth. Then gently rub the
entire chassis until it is dry again.
Fuse compartment
Prying open with small screw driver
