b. Control output strike duration (default 1s)
#2xx
xx: 00-99s
c. Hold open code
#3xxxxx
xxxxx: 5 digit code (00000-99999)
3.
Erase Mode
Selected by Mode SW (“
ERAS
” position), "Yellow” light flash.
Erase Key Code:
Enter 4 or 5 key code
Erase Card Code without Card ID:
Sweep the card.
Erase Card with Card ID:
Enter card ID #5xxxx.
xxxx: 0000-1999 card ID
Erase Command:
#911
Erase all codes
#913
Erase hold open code
Status:
Beeping twice with green light:
Erase success
Beeping once with red light:
Erase fail
4.
Program RF Receiver
Platinum RF receiver needs to be programmed to save the RF control
code of this unit.
a.
Set the unit to “
NORM
” mode.
b.
Program one card per the steps above.
c.
Place RF receiver close to this unit, Turn on RF receiver power.
d.
Open RF receiver cover and locate the programming button.
e.
Push the programming button in RF receiver.
f.
When the programing LED is on in RF receiver, sweep the card.
g.
When the programming is done, the programming LED will go off.
h.
Sweep the card again, and check the relay in receiver is activated.
i.
If the programming is unsuccessful, repeat step d to g.
5.
Slave Mode
When the unit is set to “SLAVE” mode, all key and card will sent to
master to process. Master will send “Open Gate” command upon valid
code.
6.
EXIT Input
“EXIT” input will activate control output at any time.
