11.
Make up 2 pushrods as illustrated below. Use the 0.8mm carbon rod, “Z” bend and figure “4”
supplied in this kit. Use heat gun to shrink the heat shrink tight and do
NOT
glue. Length of the
rudder pushrod is 3 inch and the elevator is 3
¾
inch.
12.
Next, install a HFX-900 receiver. Use double-stick foam tape to mount the receiver 1/8 inch from
the front of the cutout so the battery will slide in and attach. NOTE: MR Shoestring shown in
picture.
13.add centering magnets to MicroACTs using Duco Household cement. To mount a centering magnet, first
determine the correct orientation. The centering magnet should attract the magnet on the moveable arm.
(see below)
14. Next, add a small drop of glue to the magnet and mount it on the coil. The attraction will hold it there
while the glue dries. Position the magnet to get the output arm perpendicular to the coil.
