30
www.planta.ru.com
2. Connect wires to the device & accessories as shown in the figure below. Before connecting the
connection wires to the device, make sure that the device is turned off. Hold the insulated parts
of the connecting wire, insert the connecting wire plug into the connector of the corresponding
channel on the lower part of the device housing. Verify that the wires are connected correctly.
The myostimulator has two channels. You can use one channel or two channels together by c
onnecting connection wires to one or two connectors. Using two channels gives the user the
advantage of stimulating different parts of the body at the same time, and also makes it possible
to use the device at once by 2 users at the same time.
USING OF STICKERS- ELECTRODES
Remove protective from electrodes surface.
Attention!
Do not discard protective films because they will need to be glued back to the electrodes at the
end of the procedure. Detailed electrode care recommendations are listed in the "Care and
Maintenance" section!
Apply the electrode with the adhesive side to a clean dry and smooth area of the skin and press
it tightly to the skin. Ensure that the electrodes are aligned and securely fixed to the skin. If you s
elect an electrode location on the body, follow the electrode location rules in the Electrode Location
section. Do not turn on the device until the electrodes are properly attached to the skin.
3. To enable the device, insert the network adapter into the connector on the device housing and con-
nect the myostimulator to the network. Then press "ON/OFF button" on the main part of the device
housing, as shown in the figure below, at that the digital LCD display of the device will light up.
