2. Remove the image plate and prepare it for taking a new X-ray image.
4.2.4 Erasing image plate
The image data is automatically erased after scanning. Beyond that, the
image plate needs to be erased in the following cases:
•
The first time the image plate is used, or if it is stored for longer than a
week.
•
Due to an error, the image data on the image plate has not been erased
(software error message).
As erasing of the image plate is always done by the ProScanner 2.0 after
each scan of an image plate, for erasure of the image plate, please
introduce the image plate to be erased unexposed by X-ray into the scanner
as described in "Scanning image data" on page 42.
In this case the use of a light protection cover is not required. At step 4. do
not use a real patient for erasing image plates, generate a dummy patient.
4.2.5 Switching off unit
1. Press the on/off switch for three seconds.
2. As soon as the unit has shut down it switches off completely.
The LEDs go out.
4.3 Cleaning and disinfection
When cleaning and disinfecting the unit and its accessories, observe
country-specific directives, standards and specifications for medical products
as well as the specific specifications for dental practices and clinics.
4 Usage
48 Planmeca ProScanner 2.0
User's manual
