1. MAC
control
MAC Address Control allows you to assign different access right for different users and to assign a specific
IP address to a certain MAC address.
MAC Address Control
Check “Enable” to enable the “MAC Address Control”. All of the settings in this page will take effect only
when “Enable” is checked.
Connection control
Check "Connection control" to enable the controlling of which wired and wireless clients can connect to this
device. If a client is denied to connect to this device, it means the client can't access to the Internet either.
Choose "allow" or "deny" to allow or deny the clients, whose MAC addresses are not in the "Control table"
(please see below), to connect to this device.
Association control
Check "Association control" to enable the controlling of which wireless client
Can associate to the wireless LAN. If a client is denied to associate to the wireless
46
Summary of Contents for WNRT-632
