PLANET NAS-7400 User Manual
132
If your NAS-7400 is connected to your network but the Ethernet Activity LED
on your NAS-7400 is dark, check the following items:
Verify that the switch, hub, or facility network service connection
that you are using is operational.
Switches and hubs have LEDs that light when there is a connection
and flash when there is activity.
Network service connections generally do not have LEDs to verify
whether they actually are connected to the network. See your
Network Administrator for assistance.
Be sure the network cable is firmly attached to the NAS-7400
network connector at one end and to the network switch, hub, or
facility network connection at the other.
If the cable connections are good, remove the existing network
cable and install a known-good network cable.
8.11 Checking Your Email Inbox
If you enabled Mail Alert in PASM, the NAS-7400 will send you an email
message when a problem arises. Look for a message from “root.”
Email message from the NAS-7400.
8.12 Restoring the Default Password
Normally, you change your password in PASM.
If you changed the password and then forgot the new password, you can
reset the NAS-7400 to the default password: admin. Use a straightened
paper clip or the tip of a ball-point pen as a reset tool.
To reset the Administrator’s password:
i.
Verify that the NAS-7400 is fully booted.