Planet GSW-2401, User Manual

Page: 13 / 18

10 11
Chapter 4
TROUBLESHOOTING
This chapter contains information to help you solve problems. If Giga Switch is not
functioning properly, make sure the Giga Switch was set up according to instructions in
this manual.
The 10/100 or 1000 LED is not lit
Solution:
Check the cable connection and its quality.
Some stations cannot talk to other stations located on the other port
Solution:
The address table may contain older information than of the address table of
that node. Please power down to refresh the address information.
Performance is bad
Solution:
Check the full duplex status of the partner Switch or device. The partner switch
is run at full duplex and the Switch runs at Auto-Negotiation (half-duplex
mode), then the performance will be poor.
Why the Switch doesn t connect to the network
Solution:
Check the LED on the Switch
Try another port on the Switch
Make sure the cable is installed properly
Make sure the cable is the right type
Turn off the power. After a while, turn on power again