6.3.4
Wireless Configuration (FPS-1010MG Only)
Due to wireless interface is “Auto” in default. If you want to use the print server through
wireless interface, please set up the MFP server through Ethernet firstly. After configure the
wireless LAN settings, unplug the Ethernet cable from the MFP server, then you can start to
use the MFP server via wireless interface. If the wireless configuration does not work, please
plug the Ethernet cable again and configure the print server through Ethernet until the
wireless LAN settings are correct. When the wireless interface work correctly, and you don’t
need to work with Ethernet interface, you may change the Wireless Function to “Enable” to
disable Ethernet interface.
You may select either Infrastructure Mode or Ad-hoc Mode for this print server to join your
wireless network.
6.3.4.1
Infrastructure Mode
If you are select “Infrastructure Mode” and click “Next” in section 7.11, you will see the dialog
box below. You can select first option to scan your wireless network to search the Access
Point that you want to connect. Or you can select the second option and enter the SSID you
had known into the field. Please choose one of them and click “Next”.
29
