Planet 802.11n Wireless ADSL 2/2+ Router ADN-4000, User Manual

Page: 40 / 91

this wireless router is enabled, you’ll see
" Configured " message here. If wireless security
function has not been set, you’ll see
" Unconfigured ".
WPS mode When PIN code is selected, you have to enter the
8-digit PIN code of the wireless client you wish to
connect to this router. If PBC mode is selected,
just click " Start WPS " button to start WPS mode.
AP self PIN Code The PIN code of the router. You can enter the PIN
code of the router to the wireless client so the
wireless client can start WPS mode to connect to
the router. The security settings of the router will
be set to the same as the wireless client.
Enrollee PIN Code Enter the PIN code of the wireless client here. If
you have entered the PIN code of the wireless
client and switch to the WPS mode, the security
settings of the wireless client will be set to the
same as the router.
WPS progress
Display the progress during WPS communication.
Reset to OOB Click this button and all the wireless settings of the
router will be reset to factory defaults.
SSID The SSID (up to 32 printable ASCII characters) is
the unique name identified in a WLAN. The ID
prevents the unintentional merging of two
co-located WLANs. The default SSID of the router
is " default ".
Authentication Type It’s very important to set wireless security settings
properly. If you don’t, hackers and malicious users
can reach your network and valuable data without
your consent and this will cause serious security
problem.
This router supports WEP, WPA-PSK and
WPA2-PSK authentication type. If the router has
enabled the authentication, all the wireless clients’
settings have to be consistent with the router for
40