IV CORE
UPGRADE KIT
ADVANCED IV CORE INFORMATION:
The IV Core Bolt and Can can be maintained in exactly the same way the Can and
Bolt depicted in your GEO User Manual.
However, the Propshaft may require some further maintenance that is not covered
in your User Manual.
ADVANCED BOLT SYSTEM
MAINTENANCE
This procedure is only required if you are maintaining
the rear section of the propshaft assembly due
to a leak coming from the front of the bolt. After
maintaining the front 14x2 propshaft o-ring and 017
internal can o-ring.
Firstly remove the bolt system assembly, then
separate the bolt can and propshaft assemblies as
detailed on pages 48-49 of the GEO 3.5 manual.
Go to
planeteclipse.com
for the latest versions of our
manuals and instructions, for reference.
Push down on the split in the delrin retaining ring and
pull the retaining ring out of the propshaft back cap
(see figure 20A)
.
Remove the propshaft from the back cap, taking care
not to lose the propshaft spring, plunger or plunger
o-ring.
Check the 14x2 o-ring at the back of the propshaft,
and clean or replace then re-lubricate with Eclipse
Grease as necessary. Check the rear bumper for
signs of wear, replace as necessary
(see figure 20B)
.
Place the spring within the propshaft
(see figure 20C)
.
Replace the back cap over the rear of the propshaft,
pushing the propshaft back into the back cap
(see figure 20D)
1
.
Compress the retaining ring
(see figure 20E)
and
push the retaining ring into the back cap. The
retaining ring needs to sit in its designated groove in
the back cap. If the propshaft can be pulled out of
the back cap then the retaining ring has not seated
correctly.
1 If any o-rings or the bumper are damaged then replace them.
Extra o-rings and bumpers are available in parts kits available
at www.planeteclipse.com.
WARNING!
Always de-gas your
marker, discharging
any stored gas in a safe
direction, and remove the
barrel, loader, air system
and any paintballs to make
the marker easier and
safer to work on.
IMPORTANT!
Your GEO MUST be chronographed before use!!
FIG 20A
FIG 20C
FIG 20E
FIG 20B
FIG 20D
MAN0016-V2