Planar PD8130 Installation Instructions Download

Page: 3 / 4

020-0960-00 Rev. B

PREL

IMINA

Removing the Standard

Lens

7. Remove the foam shield around the front of the lens and set it aside. (You

will install it on the replacement lens later.)

8. Remove the two (2), black plastic retaining clips on either side of the lens.

Each clip is held in place with two (2), captive Phillips screws. The white,

plastic standoffs serve as “handles” to make removing the clips easier.

9. Carefully remove the lens from the lens cavity by pulling it straight out, then

tilt it upward to allow the vertical lens shift adjuster to clear the opening at

the front of the projector.

Summary of Contents for PD8130

Page 1: ...tandard lens and replace it with the short throw lens 1 Using a Phillips screwdriver remove the two screws holding the projector front cover in place 2 Gently pull the cover away from the projector at...

Page 2: ...4 Remove the center top and center bottom Phillips screws securing the left and right halves of the light shield to each other 5 Remove the two Phillips screws holding the left half of the shield in p...

Page 3: ...the two 2 black plastic retaining clips on either side of the lens Each clip is held in place with two 2 captive Phillips screws The white plastic standoffs serve as handles to make removing the clip...

Page 4: ...e facing down and to the left 11 Insert the short throw lens into the lens cavity Ensure that the notch on the vertical lens shift adjuster mates with the retaining slot on the projector as shown at r...