EL640.480-AF1 VGA Operations Manual (020-0349-00A)
3
Installation and Handling
The mechanical package consists of the display panel and electronic circuit
board adhesively bonded together and mounted in a plastic bezel. The bezel
supplies the mounting ears and protects otherwise exposed leads. The display
is made of glass material and must be handled with care.
CAUTION: The display uses CMOS and power MOSFET devices. These
components are electrostatic sensitive. Unpack, assemble, and examine this
assembly in a static-controlled area only. When shipping, use packing
materials designed for protection of electrostatic-sensitive components.
Do not drop, bend or flex the display. Do not allow objects to strike the surface
of the display
Mounting
The AF1 display was designed to facilitate the mounting of optical treatments
and touch screens on the viewing side of the display. To this end, the glass
extends in front of the mounting bezel by approximately 0.5 mm (0.02") It is
imperative that any mounting scheme apply uniform pressure across the glass
at all times. Pressure applied only to the corners or edge of the glass is likely to
cause breakage.
Mounting should be done using the mounting ears only. Use either metric M3
screws tightened to 350 Ncm maximum, or unified #4 screws tightened to 4.7
in/lb maximum.
CAUTION: Properly mounted, this display can withstand high shock loads
and severe vibration in aggressive environments. However, the glass panel
used in this display will break when subjected to bending stresses, high
impact, or excessive loads.
To prevent injury in the event of glass breakage, a protective overlay should
be used on the viewer side of the display.
WARNING: These products generate voltages capable of causing personal
injury (high voltage up to 230 V
ac
). Do not touch the display electronics
during operation.
