A
ppendix
37
4. Remove the lamp unit.
•
Loosen the securing screws from the lamp unit. Hold the lamp unit by the handle and pull it in the direction
of the arrow.
5. Insert the new lamp unit.
•
Press the lamp unit firmly into the lamp unit compartment. Fasten the securing screws.
•
Attach the lamp unit cover.
•
Close the lamp unit cover in the direction of the arrow (to the close mark) on the side of the projector.
•
Tighten the cover screw.
Info
•
If the lamp unit and lamp cover are not correctly installed, the power will not turn on.
Resetting the Lamp Timer
Reset the lamp timer after replacing the lamp.
1. Connect the power cord.
•
Plug the power cord into the AC socket of the projector.
2. Reset the lamp timer.
•
In the OSD Main menu, press
S
or
T
button to select
Option
menu.
•
Press
W
or
X
button to select
Lamp Timer Reset
.
•
Press
to confirm, and “LAMP 0H“is displayed. The lamp timer is reset.
Info
Only reset the lamp timer when replacing the lamp. If you reset the lamp timer and continue to use the same
lamp, this may cause the lamp to become damaged or explode.
SOURGE
MENU
ENTER
SOURGE
MENU
ENTER
SOURGE
MENU
ENTER
ENTER
Summary of Contents for DLP PD7130
