3
PixelArt Batten mounting
LINK
LIN
K
A
C
TIVITY
A
C
TIVITY
ER
R
O
R
ERR
OR
SOURCE
SOURCE
MAX PO
WER 100W
90 – 240V
A
C
47 – 63H
z
FUSE 3.15A SLO
W
B
L
O
W
B
A
www
.pix
elrange
.com
PU
SH
PU
SH
LINK
A
CTIVITY
ERR
OR
SOURCE
B
A
www
.pix
elr
a
PU
SH
Use a safety wire
Ensure that all PixelArt Battens
mounted off-ground are protected
using a secure safety wire (rated
to at least 15Kg, 33lbs) through
the eyelet situated adjacent to the
connection panel.
Supplied Omega brackets
Each PixelArt Batten is supplied with two ‘Omega’
brackets (plus fixings) which attach at the top and
bottom of the rear panel.
For each bracket
1 Insert the two screws into the sockets at the top
left and bottom right holes of the fixing area.
Leave them loose.
2 Securely fit the required clamps to each of the
omega brackets using the supplied bolts, wash-
ers and Nyloc
®
nuts.
3 Offer the bracket to the screws so that the
curved slots engage, then rotate the bracket
anti-clockwise. Tighten the screws.
4 Insert the two twist lock bolts into the top right
and bottom left holes and twist them clockwise
to lock the bracket in place.
5 Double check that each bracket is secure and
use a safety wire (see below).
Optional U-brackets
Optional U-brackets allow greater
tilted angles for PixelArt Battens.
For each bracket
1 Place the supplied fibre washers
between the U-bracket and the
side holes of the PixelArt Batten.
2 Place the metal washers onto the
screws and insert them through the
bracket and the fibre washers into
the side holes.
3 Tighten the screws and double
check that the bracket is secure.
4 Use a safety wire (see left).
IMPORTANT: If a fall is arrested by
the safety chain, the fixture must be
returned to the point of purchase for
checking before it is re-used.
