General Purpose I/O Connector: Enclosed
Camera
The mating connector is an 8-pin Hirose HR25A-
&P-8P cable plug with solder pins for 28 AWG
wires.
General Purpose I/O Connector: Board
level Camera
The connector is an 8-pin 1.25mm Molex connector
located on the interface board.
The mating connector is a Molex 51021-0800
receptacle with Molex 50079-8100 wire crimp
terminals.
Trigger Notes:
1.
To initiate a positive trigger, apply a voltage
of between 5V and 12V (4-11mA) to the
optically trigger input terminals.
2.
The optically isolated trigger input includes
an internal 1Kohm resistor.
3.
When using a trigger voltage higher than
12V, add an external series resistor with an
adequate power rating.
4.
Debounce delay is 1 microseconds.
External Trigger Connection Examples
Some examples of external trigger setup.
Example 1: HCMOS Source trigger
Example 2: HCMOS Sink Trigger
Example 3: Synchronizing PL-D cameras with
Push Button
For detailed information on external trigger setup
please visit:
External Trigger Examples
