Unpack table from box. Turn table
upside down on a protected surface.
1.
6.
2
Extend legs on both ends of the
table into the upright position.
2.
Install 2nd (lower) bolt on all (4) legs.
Insert bolt, (2) washers and then nut.
Hand tighten all bolts.
3.
4.
Tighten all (8) leg braces bolts using
9/16” socket and 9/16” wrench.
5.
Turn table right side up and put the lower shelf into place.
The underside of the shelf has velcro that will match up
with velcro at each end of the table on the leg braces.
Your Edge Sport table is now ready for use.
*NOTE: Routinely check table to make sure all hardware is tight and tighten accordingly when necessary.
EDGE SPORT Assembly Instructions
Install H-Brace into slit on the
leg brace, with (4) 1-1/4” screws.
