17
/124
17
/28
This manual is the property of PIUSI S.p.A. Any reproduction, even partial, is forbidden.
translated from italian
delphin PRO - IBC - PRO_X
EN
13.5 PARTIAL RESET (NORMAL MODE)
The partial register can be reset by pressing the reset key when the
meter is in standby, meaning when the display screen shows the word
“TOTAL”.
After pressing the reset key, during reset, the display screen first of all
shows all the lit-up digits and then all the digits that are not lit up.
At the end of the process, a display page is first of all shown with the
reset partial and the reset total.
and, after a few moments, the reset total is replaced by the non reset-
tableTotal.
13.6 RESETTING THE RESET TOTAL
The reset total resetting operation can only be performed after reset-
ting the partial register. The reset total can in fact be reset by pressing
the reset key at length while the display screen shows reset total as
on the following display page:
Schematically, the steps to be taken are:
1 - Wait for the display to show normal standby display page (with
total only displayed)
2 - Press the reset key quickly
3 - The meter starts to reset the partial
4 - While the display page showing the reset total is displayed
Press the reset key again for at least 1 second
5 - The display screen again shows all the segments of the display
followed by all the switched-off segments and finally shows the display
page where the reset Reset Total is shown.
