Pittway NOTIFIER LED-10N, Manual

Page: 8 / 24

8
Document 50581 Rev A 12/9/96 P/N 50581:A
ADDRESS SWITCH SETTINGS ADDRESS SWITCH SETTINGS
1 2 3 4 5 6 1 2 3 4 5 6
INVALID 0 0 0 0 0 0 17 0 1 0 0 0 1
01 0 0 0 0 0 1 18 0 1 0 0 1 0
02 0 0 0 0 1 0 19 0 1 0 0 1 1
03 0 0 0 0 1 1 20 0 1 0 1 0 0
04 0 0 0 1 0 0 21 0 1 0 1 0 1
05 0 0 0 1 0 1 22 0 1 0 1 1 0
06 0 0 0 1 1 0 23 0 1 0 1 1 1
07 0 0 0 1 1 1 24 0 1 1 0 0 0
08 0 0 1 0 0 0 25 0 1 1 0 0 1
09 0 0 1 0 0 1 26 0 1 1 0 1 0
10 0 0 1 0 1 0 27 0 1 1 0 1 1
11 0 0 1 0 1 1 28 0 1 1 1 0 0
12 0 0 1 1 0 0 29 0 1 1 1 0 1
13 0 0 1 1 0 1 30 0 1 1 1 1 0
14 0 0 1 1 1 0 31 0 1 1 1 1 1
15 0 0 1 1 1 1 32 1 0 0 0 0 0
16 0 1 0 0 0 0
NOTES:
1) EIA-485: Maximum of 6,000 feet total cable length from FACP to LED-10Ns. Circuit is power-
limited.
2) Up to 32 LED-10Ns may be used on the EIA-485 circuit. The SFP-1024 can power a maximum
of seven LED-10Ns. If additional LED-10Ns are connected, the Notifier FCPS-24 may be used
to supply additional power. (Power supplies used for this purpose must have their negative
terminals commoned together).
3) Between each LED-10N are four wires: A twisted-shielded pair for data communications and a
pair for 24 VDC power.
Figure 1-4: Typical Configuration
Table 1-1: LED-10N Addressing
Typical Configuration
The LED-10N indicates the status of the SFP-1024, while offering multiple annunciator
locations with the capability of remote Acknowledge, Signal Silence, Drill and Reset
functions. The LED-10N displays zone status and requires no programming.
General Information
www.PDF-Zoo.com