Pittway NOTIFIER AFM-16AT, Installation Manual

Page: 8 / 28

Document 15048 Rev. D1 07/16/97 P/N 15048:D1
8
AFM Installation Summary
Run the EIA-485 and power circuits out to the location of the annunciator.
Select an appropriate knockout on the backbox and mount the backbox.
Connect the backbox to a solid ground, such as a properly grounded
metallic cold water pipe.
Draw all annunciator and power wiring into the enclosure. Do not
terminate the shield (if employed) to the backbox (see Figure 3-2).
Insert the custom display labels into the annunciator (see Figure 3-3).
As appropriate, cut jumper options on the annunciator as outlined in
Figure 3-4.
ABF-1 Only - Turn the ABF-1 Dress Plate face down on a surface with
the screw studs facing up. Position the AFM-16AT over the screw studs
and secure to the dress plate with the two nuts and lock washers provided
(see Figure 3-5).
ABF-1 Only - Remove the backing from the Annunciator Label and affix
to the dress plate as illustrated in Figure 3-6.
ABF-1 Only - If employing an Annunciator Key Switch (AKS-1), mount
the switch to the dress plate. Plug the switch leads to Connector J4 on
the Annunciator (see Figure 3-7).
ABF-1 Only - If employing an Annunciator Phone Jack (APJ-1), mount
the jack to the ABF-1 Dress Plate. Connect the telephone circuit to the
leads of the APJ-1(see Figure 3-7).
Connect power-limited EIA-485 circuit and power-limited power wiring to
the Annunciator Terminal Blocks as illustrated in Figure 3-8.
Place the annunciator/dress plate assembly into the backbox and secure
with two screws.
Connect the EIA-485 circuit to the CPU as illustrated in Figure 3-9.
Connect the power loop for the annunciator to the Main Power Supply as
illustrated in Figure 3-10.
Installation of the AFM Annunciator is complete. Program the AFM into
the respective CPU and full test the system.
❑
❑
❑
❑
❑
❑
❑
❑
❑
❑
❑
❑
❑
❑
Section Three: Installation
www.PDF-Zoo.com
firealarmresources.com