Page 2
For technical questions, please call 1-888-866-5797.
Item 63757
Specifications
Glue Gun
120VAC, 40W
Crossbar Adjustment
3″ to 5″
Important Safety Information
1. Wear ANSI-approved safety
goggles and heavy-duty
work gloves during use.
2. This product is not a toy.
Do not allow children to play
with or near this tool.
3. Use as intended only.
4. Inspect before every use; do not
use if parts are loose or damaged.
5. Maintain product labels and
nameplates. These carry
important safety information.
If unreadable or missing,
contact Harbor Freight Tools
for a replacement.
6. Keep glue gun dry,
do not use in rain.
7. People with pacemakers should
consult their physician(s) before
use. Electromagnetic fields
in close proximity to heart
pacemaker could cause pacemaker
interference or pacemaker failure.
Instructions
1. Insert Glue Stick (2) into
Glue Gun (1). Plug in Glue Gun
and allow to warm up for ten to
fifteen minutes before use.
2. Using clean cloth (not included),
clean dent area with Release
Agent (3). Then apply heated
glue from Glue Gun to end of
desired Pull Tab (4, 10).
3. Place Pull Tab on center of dent
and hold there for ten seconds.
WARNING!
Do NOT push Pull
Tab against dent.
4. Place Cross Bar (5) over Pull Tab,
setting Adjusters (9) to desired
length. Thread Wing Nut (6)
onto end of Pull Tab. Continue
to twist Knob until dent is
raised. Stop when dent returns
to normal surface level.
5. Unthread Knob and remove Cross
Bar and Pull Tab from surface.
Apply two drops of Release Agent
to spot of dried glue. Use Scraper
to peel off softened glue patch.
6. If a high spot has been created,
use a hammer (not included)
and lightly tap Dowel (8)
against raised spot until desired
smoothness is reached.
Note:
The Repair Kit will not repair
ALL kinds of dents, regardless of size.
The Repair Kit will also not work
on aluminum panels or surfaces.
