Page 5
For technical questions, please call 1-888-866-5797.
60234
Operation
Read ENTIRE IMPORTANT SAFETY INFORMATION section at beginning of this manual
including all text under subheadings therein before set up or use of this product.
Removing a Transmission
1. Before every use, check and/or fill Hydraulic Fluid.
2. Once the vehicle is raised and secured on a lift, clear
the area underneath the vehicle of people and tools.
3. Remove the Chain and set aside.
4. Move the Transmission Jack
underneath the transmission.
5. Close the Release Valve.
6. Pump the Handle to raise the Transmission Jack.
7. Stop just below the transmission and align the
Saddle to the Transmission with the Tilt Knobs.
8. Continue raising the Saddle up to the transmission
to determine where you will need to adjust
the Supports. All four Supports need to grip
and make contact with the transmission.
9. After determining where they need to be set,
loosen the threaded bolts on each Support,
and adjust it to the proper setting
for the transmission. Tighten the bolts.
10. Raise the unit again to make contact
with the transmission, making sure all of
the Supports are in firm contact.
11. Hook the chain on the open bracket,
wrap the Chain securely around the transmission,
and hook the chain hook through the other end.
Tighten the Chain Hook securely to tighten the chain.
12. Once it is securely fastened, release the
bolts holding the transmission in place.
13. Make sure the area is clear of people and tools, and
verify that the transmission is securely held in place.
Then, slowly open the Release Valve
to lower the Transmission Jack.
14. Move the Transmission Jack from under the
vehicle and perform your desired maintenance.
Replacing a Transmission
1. Move the Transmission Jack so that the transmission
is lined up properly with its connection points.
2. Close the Release Valve.
3. Pump the Handle to gradually raise the
Transmission Jack, while guiding it into place.
4. Secure the transmission into
place using its hardware.
5. Double-check to make sure the
transmission is securely installed.
6. Disconnect the Chain and remove it.
7. Clear the area near the Transmission Jack, and
slowly open the Release Valve to lower the Jack.
8. Move the Transmission Jack clear of the vehicle.
