2017
FTC Tomahawk Instructions
Step 8: Arm Motor Mount
Hardware:
Motor mount (x1), 1.25" SHCS (x1), motor mount screws
1.5"
(x1), nuts (x2)
Instructions:
Position the screws as shown on the motor mount. One of the screws will be longer
than the other; this is fine, because one side of the motor mount is longer than the other. So place
the longer screw in the longer (clamping) side; the screws should come out even in the end. Add
the motor mount in the holes indicated, clamping side facing up
Step 9: Driving Motor Mounts
Hardware:
Motor mount (x2), Motor Mount screws (x4), kep nuts (x4)
Instructions:
Attach the motor mounts onto the base with the screws and nuts. The motor mounts
should are offset by one screw hole towards the center of the chassis, not in the center of the
channel. As in
Step 8
, the longer motor screw goes into the clamping side of the mount. We
suggest placing the clamping side to the back of the robot.
Note:
There are actually two motor mounts in the picture; they are not connected.
*
Srishti Kumar, FTC #7172
Lauren PeCoy, FTC #8204
Patrick R. Michaud, UT-Dallas
v2017.06.2
4
