9) Clip the black and red wires from the solar panel to the motor
connection terminals. You might need to turn the motor in the mount so
the connection clips do not stick up and interfere with the solar panel
placement.
10) Place an adhesive tab on the back of the solar panel near the wire end.
Peel the paper backing off the tab and carefully place the solar panel on
the car so it angles down from the motor to the chassis. The tab should
rest on the motor and the other end of the panel will be near the front of
the car (Figure 3).
11) Following the directions on the car body cutout, cut and fold the car body.
12) With the blank underside of the cutout facing up, place an adhesive tab on
the two tabs that extend from the cutout. Practice folding the cutout over
the car so the tab on the wide end is aligned with the car’s back and the
tab on the narrow end is at the front. The cutout should fit over the car so
the solar panel shows through the hole in the cutout.
13) When you are comfortable with the positioning of the cutout, remove the
backing on the tabs and adhere the cutout to the chassis.
Note:
You may
need to reposition the clips if they are pushing on the cutout so it rubs
against the gear or wheels.
14) Take the completed SunEzoon Car outside on a clear, bright day and place
it on a smooth, level surface. If properly connected, it will take off. If it
runs backward, switch the red and black wires on the motor connection
terminals.
59021 V0808
Solar Panel
Motor in
Motor Mount
Adhesive
Tab
Chassis
Figure 3
Summary of Contents for SunEzoon Car
Page 1: ...User Guide 59021 V0808...
