SV62751 Rev. A | Operator Guide
10 | SH39 Shredder
Material Jam
When too much material is being fed in either feed slot, the cutters jam, run in reverse for a short time
(material is released), and stop. The motor turns off and the operation error icon lights up. To fix:
Paper
1. Remove the paper that has been fed back.
2. The cutter starts running forwards automatically and shreds the remaining paper.
3. Continue shredding with less paper.
CD/DVD Media
1. Remove the media that has been fed back.
WARNING! Remove the material carefully as there is the risk of being injured by the
sharp cut surfaces.
2. The cutter starts running forwards automatically and shreds the remaining media. If necessary,
switch the cutters manually from forward to reverse until the material has gone through
completely and been shredded
3. Continue shredding by feeding
one piece in at a time
.
Material Sensors Blocked When Collection Bin Opened
If there is material in one of the two feed slots when the collection bin is opened, the motor turns off
and the cutters stop. The operation error icon lights up.
Push in the bin and press the
forward
button briefly. The existing material is fed to the cutters and
shredded.
Electrical Fault
If the motor/electrical fault icon flashes together with the ON/Sleep/Stop button being lit, or
only the collection bin open/fault icon flashes, there is an electrical fault. The machine cannot be
started. Call for servicing.
Check List
If the machine isn’t working, check the following:
• Is the plug connected to the AC outlet?
• Is the operator interlock enabled?
• Is the collection bin properly pushed in?
• Is the collection bin full?
• Is there a material jam in the machine?
• Is there a motor overload condition?
If you can’t resolve the issue, please call for servicing.
Troubleshooting
