15
Operation
1. Place one envelope on the belt.
2. Loosen the front and rear end side
guide knobs
(A) of the side guide with
the sensor bracket only.
Make sure the side guide rests on
the belt!
3. Adjust the side guide to give a
clearance of about 3mm (1/8”) and
retighten the front and rear end side
guide knobs.
Make sure the side guides are parallel!
4 Loosen the Brush adjustment knobs
(B)
and set the brush position on the Entry
guide. The brushes should just about
touch the envelope. Retighten the
adjustment knobs.
The setting depends on envelope size,
thickness, inserter speed and belt
speed.
If the brushes are set too tight the
envelopes will not get in position.
If the brushes are set to loose the envelopes could bounce back and cause
jams.
5. Read the safety information on page
2, then connect the Conveyor Stacker
to the mains supply and turn ON.
6. Set the belt speed to maximum.
2.6 Operation with the DI875
A
3mm clearance
B
Brushes just touch envelope