Pit Boss Navigator 850, Assembly Manual

Page: 7 / 12

7
EN
ENGLISH
6. MOUNTING MAIN BARREL TO THE CART
Parts Required:
1 x Main Barrel
(#4)
1 x Cable Clips (#31)
1 x Power Cord
(#32)
12 x Screw (#A)
12 x Washer
(#B)
12 x Locking Washer (#C)
Installation:
• Place the Cable Clips on the Power Cable. Insert the power cord into a groove
at the bottom of the hopper.
• Secure the wire clip to the hopper using screws pre-installed at the bottom of
the hopper. Note illustration 6A.
• Secure the wire Prepare the Main Barrel to be mounted to the Cart.
Carefully, lift the Cart into an upright position with the wheels on the
bottom. Position the Cart next to the Main Barrel, with both facing
the same direction. Lock the Caster Wheels on the Cart. Using a second
person, prepare to lift the Main Barrel onto the Cart. With one person
lifting from the hopper side, and the other person lifting from the
opposing barrel end, carefully lift the Main Barrel, and slowly lower onto
the Cart. Note illustration 6B.
• Next, open the Main Barrel lid. Adjust the rotation as needed to align
the screw holes of the Main Barrel to the Cart. Once placed, secure each
leg to the Main Barrel using three screws, washers, and locking washers.
Note illustration 6C.
7. SECURING SUPPORT PLATES TO THE GRILL
Parts Required:
4 x Screw
(#E)
Installation:
• Secure each Long Support Plate to the Main Barrel using two screws .
8. INSTALLING THE LID STOPPER
Parts Required:
1 x Lid Stopper
(#1)
Installation:
• Secure the Lid Stopper onto the top of the Main Barrel using the pre-
installed screw on top of the Main Barrel.
6B
4
6C
B
A
C
8
1
7
6A
31
32