Programming Sensors with Repeater
Turn Switches No.4, 5, 6 7 to ON position, you will see SEND LED
light on. Trigger the sensor which you need to program, and you will
see SEND LED light flash twice, which means successful
programming. Then switch off that sensor, and trigger the second
sensor to program it with Repeater, and so on. WHEN FINISHED,
TURN SWITCH No.7 TO OFF POSITION.
Deleting Programmed Sensors from Repeater
Turn ON both switches No.7 and No.8 within 15 seconds of unplugging power. Then plug in the
power adapter, and you will see SEND LED light flash 3 times, which means all programmed
sensors are deleted from the Repeater.
If you do not want to program sensors to Repeater, please just keep
Switches No.4 and No.5 ON, and all others OFF. The Repeater will
transmit signals to all sensors without programming.
Operation Instruction
1. Install antenna: Install two antennas to the Repeater as shown below. They must be tightened.
2. Locate the Repeater to a proper position: Place the Repeater in midway between the Sensors
and Console. Change location according to the sensors and console's signal strengths, and adjust
the Repeater to a proper position.
3. Set Repeater's transmission mode: Plug in DC 12V Power adapter. When Power light is on,
Repeater starts to transmit data automatically (set all switches' positions as explained above)
ATTENTION
1. Keep antenna upward, and away from metal objects and the wall when installing.
2. DO NOT INSTALL OUTSIDE. RAIN OR WATER MAY DAMAGE THE REPEATER.
3. If the Repeater cannot receive signal, first make sure the Repeater is able to receive the
sensors' signals. If no signal is received, move the Repeater close to sensors until it receives
sensors' signals. Then adjust console's position close to the Repeater until the Repeater receives
its Signal.
4. Power supply requirement: DC12V Output, Current > 300mA
5. Before plugging in the power adapter, DO NOT TURN ON switches No.7 and No.8 together,
otherwise all programmed sensors will be deleted.
