Wireless Signal Repeater
Mode: WSRPT-02
Introduction
：
This Repeater is a wireless data transmitting equipment for the Console and the Wireless Sensors.
The signals being transmitted must meet following two conditions:
1. All devices' frequency must be synchronized with the Repeater.
2. Repeater and all devices' oscillation resistors' frequency must be synchronized.
This Repeater supports up to 100 sensors. Users may use this feature to select specific sensors to
transmit/ avoid other signals interfering each other.
Repeater Specification:
Work Frequency: 433.92Mhz
Power Voltage: DC 12V
Static Current: 30mA
Operating Current: <255mA
Receiver Sensitivity: -108dBm
Transmit Power: 500mW ( No obstacle - transmit distance up to 4500ft)
Symbol illustration:
POWER INDICATOR: Power LED
SEND LED: Transmission LED
(turns on during data transmission)
8 DIP Switches: In the bottom of the
housing. Each DIP switch has
ON/
OFF
positions as shown in left
figure. Each DIP Switch features as
explained below:
No.1, 2, 3: keep OFF
No.4: must be kept ON for all Pisector Alarm System Mode PS03
and Mode GS07 Series systems
No.5: controls transmission time. Transmit in 1.5 seconds if OFF,
in 3-5 seconds if ON. (Keep ON for reliable signal transmission.
Please keep OFF if you have more than one sensors in need of
transmission)
No.6:
transmits only programmed sensors
if set at
ON position.
(If
you have more than one Repeater at same location, you should
keep it at ON position)
Repeater will transmit all sensors and
devices having the same frequency when set at OFF position.
No.7: Keep at ON position to program sensors with this repeater.
Keep it OFF when done programming.
No.8: Tests switches. When at ON position, the repeater is always sending (PT2262 1.2M) signal.
Keep it OFF during normal working positions.
