■ How to adjust the speed (Exhaust needle type only)
1. Speed adjustment of actuators
①
Increasing speed
Turn the needle in the counterclockwise from a
fully closed state. The more the needle is
opened, the faster the actuator moves. Make sure
to tighten the locknut at the desired speed.
The
speed setting can be changed without
tightening
the locknut.
②
Reducing speed
Turn the needle in the clockwise when
the
speed is too fast. Make sure to tighten the
locknut at the desired speed. The speed setting
can be changed without tightening the locknut.
■ How to replace silencer element
1. Replacement of silencer element
①
Remove the silencer cover by loosening it in the
counterclockwise direction.
②
Remove the silencer element.
③
Attach a new silencer element to the metallic body
up to the end.
④
Place the silencer cover over the element and
tighten the cover in the clockwise direction.
※
Make sure to stop air supply before replacing
silencer element. No need to readjust the needle
after the replacement of silencer element.
Silencer element
Model code Element Model code
EQ 01-C
□
P
□
E EQSE-01E
EQ 02-C
□
P
□
E EQSE-02E
EQ 03-C
□
P
□
E EQSE-03E
Silencer cover
Metallic body
■ How to insert and disconnect
1.
How to insert and disconnect tubes
①
Tube insertion
Insert a tube into Push-In Fitting up to the tube end. Lock-claws bite the
tube and fix it automatically, then the elastic sleeve seals around the
tube.
Refer to
“
2. Instructions for Tube Insertion
”
under
“
Common Safety
Instructions for Fittings
”
.
②
Tube disconnection
The tube is disconnected by pushing release-ring to release Lock-
claws.
Make sure to stop air supply before the tube disconnection.
2. How to tighten thread
①
Tightening thread
Use a spanner to tighten a hexagonal-column or square part of the product.
Refer to
“
Table: Recommended tightening torque
”
under
“
2. Instructions for
Installing Controllers
”
in
“
Common Safety Instructions for Controllers
”
.
Hexagonal-column