Piscine Solide REFLEXION V35013, Installation Manual

Page: 26 / 42

3-8 No Diving or Jumping. Observe all Safety Rules
C. CONT. INSTALL THE POOL LINER
Section
3
GENERAL INSTRUCTIONS - ROUND POOLS
ASSEMBLING THE POOL WALL
Please ensure to follow instructions that match the type of liner you may have.
2. Fasten the liner place
2-1. For OVERLAP ONLY
(Please see step 2-2. or 2-3. for other liner)
a. Starting at the liner wall seam, hang the liner over
the wall making sure that the seam is straight up
and down, perpendicular to the floor. (Remove
stabilizers gradually as you fold the liner over the
top of the wall. )This will assure you that the liner
begins going over the wall straight.
(Image 18)
b. As you put the liner over the wall you can secure it
by using the plastic coping strips to keep it in place.
If you end up with excess material, continue around
the pool, pulling excess liner evenly, and distribute
over the wall until the excess is gone.
(Image 19)
c. Fasten the liner to the top of the wall with plastic
coping. Let the liner hang slack for now. Do not pull
the liner tight.
(Image 19)
NOTE: Some liners may fit very tightly, it is better to
install uprights, top plate and rail before going onto
next step. See Section 4.
d. Turn the vacuum cleaner on and push the liner out-
ward with your feet to iron out any wrinkles. Once
finished, turn off vacuum cleaner.
e. Start filling the pool with water. As the pool fills,
work out all the wrinkles and smooth the liner to
the wall. Remove the plastic coping around the top
edge of the wall one piece at a time and adjust the
liner. Keep smoothing out the wrinkles.
Important Note:
Do not trim off the excess liner. (If the liner ever needs to
be removed, trimming the liner will make re-installation
very difficult). Instead, roll up any excess liner and tape
it in place near the top of the pool wall.
18
19
Plastic Coping
Liner Overlap Outside Pool
Wall