13
1.
Ensure your battery is installed securely in its position
2.
Pirez supply customised securing straps
with some battery types as shown here.
These
can be
purchased via our website.
3.
Specific battery installation instructions
are not provided here due to the large
range of battery options.
4.
Refer to our website or your own battery
supplier for further assistance.
Install the Display Unit
The display unit included with the conversion kit is
the BAFANG DP-C18.
This device will support you in configuring your
wheel size and adjusting the speed limiter and power
level.
1.
Install the display and button control on the
handlebar using the two rubber grommets
and three screws supplied.
2.
Adjust its location to your preference so that it
will be easy to glance at whilst riding.
3.
Attached to the Display Unit is the Pedal Assist
Controller (PAC), which includes the ON/OFF and
control buttons.
4.
The PAC should be slid onto the handlebars on the side preferred by the rider. This
will be affected by where you placed the
Display Unit, the type of throttle you
have and your brake levers.
5.
Tighten the screw in the holder once the
switch is in a comfortable position.
6.
Plug it into the motor controller with
the power off.
7.
Keep the plug cap to reuse anytime the
cable is disconnected. This will help
protect the green plug of your display.
Install the Brake Controls
Each conversion kit includes a new set of electric brake levers.
You can choose to either install the new e-brake levers provided with your kit or purchase
a set of brake sensors to use with your existing brake system.
