Pirelli ARV3515J-A-GP, Manual

Page: 23 / 142

C
ONNECT THE
S
YSTEM
2-11
Attach to Your Network Using Ethernet Cabling
The LAN ports on the VoIP Router auto-negotiates the connection speed
to 10 Mbps Ethernet or 100 Mbps Fast Ethernet, as well as the
transmission mode to half duplex or full duplex.
Use twisted-pair cabling to connect any of the LAN ports on the VoIP
Router to an Ethernet adapter on your PC. Otherwise, cascade the LAN
port on the VoIP Router to an Ethernet hub or switch, and then connect
your PC or other network equipment to the hub or switch. When inserting
an RJ-45 connector, be sure the tab on the connector clicks into position
to ensure that it is properly seated.
Warning: Do not plug a phone jack connector into an RJ-45 port. This
may damage the VoIP Router. Instead, use only twisted-pair
cables with RJ-45 connectors that conform with FCC
standards.
Notes: 1. Use 100-ohm shielded or unshielded twisted-pair cable with
RJ-45 connectors for all Ethernet ports. Use Category 3, 4, or 5
for connections that operate at 10 Mbps, and Category 5 for
connections that operate at 100 Mbps.
2. Make sure each twisted-pair cable length does not exceed
100 meters (328 feet).