Page 12 of 24
7
Safety Devices Operation
NOTE
: The motor has an overheating protection device built in.
It will automatically switch off power to the motor if it overheats. e.g. from
blocked nozzles, full dust Canister or uncleaned blocked filters.
If this happens, turn off the vacuum and unplug from power socket, clean
blockage and / or filters and allow to rest for at least 60 minutes which should
be enough time for the motor to cool down.
Important
: If the over-temperature device activates and turns the motor off,
and you do not switch off and unplug the appliance from the power point, the
motor will restart automatically after it has cooled down enough to reset the
safety device.
NOTE
:
NEVER BLOCK ANY VENTS OR OPENINGS
.
8
Emptying the Dust Canister
Empty the Dust Canister and clean the filters as frequently as possible or
when the suction power is reduced.
•
To remove the Dust Canister, turn off the power and
unplug.
•
Grip the handle on the Dust Canister, press the Dust
Canister Release Button and pull the Dust Canister forward
and out of the housing.
•
Take the dust Canister to a dustbin.
•
Press the Trap Door release button on the lower part
and the trap door will swing open emptying the
contents into the bin.
To close the trap door, close it manually until it clips
shut.
•
Brush the inside of the dust canister with a small brush
or wash Refer to section “Cleaning Filters”.
•
To refit the Dust Canister in to the vacuum cleaner, simply align the
dust canister into its position and push in until it locks in place.
