background image

INSTRUCTIONS FOR USE

Cocking Rod

Velocity

Adjustment

Screw

On/Off Button

Sear Release

Gas Thru Grip

On/Off Indicator

Charge Port

Drop Forward

PMI High Performance Barrel

10º Bottom Line

Adapter

RAVAGE

The Ravage eForce grip frame is capable of high rates of fire and an agitating hopper such as an
Extreme Rage Overdrive, VL Revolution, Halo, or Evolution 2 is recommended for better performance.

SEAR RELEASE SLIDE

:

The sear release slide is located on the left

hand side of the Ravage grip frame. To reinstall the bolt/block/hammer
assembly, push the sear release slide up before the hammer comes in con-
tact with the sear. That will allow the bolt/block/hammer assembly to slide
easily into the marker.

ON/OFF BUTTON:

The on/off is the silver button 

located on the left hand side of the gripframe. Push it once
and the red on/off indicator will then light up. Push the
on/off button again to turn it off. The frame should be left 
off when not using the marker or you will drain the battery. 

RAVAGE BATTERY:

The Ravage comes with a 9 volt rechargeable battery. You must charge it for a full 22 hours before initial use since the it does not come fully charged.

For best long term battery life, repeat this process every time it is drained. You can also use a regular 9 volt battery with this frame if your rechargeable battery is dead or if you
want to play with the frame right away. You will need to remove the right grip panel when you need to replace it.

WARNING:

PMI RECOMMENDS USING THE 9V RECHARGEABLE BATTERY PROVIDED FOR OPTIMAL PERFORMANCE. DO NOT

USE THE BATTERY CHARGER WHEN USING ANY NON-RECHARGEABLE BATTERY.

BURST BUTTON

Press the Burst Button once to turn the marker on 3

Shot Burst. Press the Burst Button again to turn the frame to 6 Shot Burst.
Press the Burst Button again to turn the frame to 9 Shot Burst. Press the
Burst Button again to turn it back to semi-auto.  

FULL AUTO BUTTON

Press the Full Button once to turn the frame to

Full Auto. Press the Full Button again to turn it back to semi-auto.

eFORCE BATTERY

The eForce frame comes with a 9 volt

rechargeable battery. You must charge it for a full 22 hours with the
marker turned off before initial use since it does not come fully
charged. For best long term battery life, repeat this process every
time it is drained. You can also use a regular 9 volt battery with this
frame if your rechargeable battery is dead or if you want to play
with the frame right away. You will need to remove the right grip
panel when you need to replace it. A blinking on/off indicator light
means your eForce frame needs to be charged right away. Always
charge with the marker turned off.

TOURNAMENT LOCK SWITCH 

The Tournament Lock Switch

enables you to play in a tournament or at a field that does not allow full
auto and burst modes by restricting the marker to semi-automatic only. All
eForce frames come with the Tournament Lock off so you can immediately
put the marker in full auto or burst mode. See Piranha manual (5.3) page
32 or Piranha manual (5.1) page 28.

WARNING:

Never use water to clean the marker, or you run the risk of damaging the electronic trigger frame. 

Reviews: