Page 19 of 20
14 Troubleshooting
Noisy operation
Clean the Filters and empty the Dust Canister
Check for partial blockages and unblock.
Suction Not Strong
Clean the Filters and empty the Dust Canister.
Check for blockages and unblock
Check that the Suction Relief Valve on the hose
handle is closed.
Over-heating / Stopping
Clean the Filters, empty the Dust Canister, check for
blockages and unblock then allow it to cool for up to
hour before trying to restart.
Floor Brush hard to push
Due to the strong suction of your vacuum cleaner, it
may be difficult to push, especially over thick carpet.
Rather than force the Floor Brush, lift the Floor Brush
momentarily to allow air to flow into the vacuum
releasing the built up suction pressure, then continue
vacuuming.
The Floor Head brush may be extended when using
on a carpet. Retract the brush.
Slide open the vacuum Suction Relief Valve located
on the hose handle. This will reduce suction to the
floor head.
Suction is Too Strong
You can adjust the suction power by adjusting the
Variable Speed Control by sliding is to the left. For
Max suction, slide to the right.
Refer to section “Variable Speed Control”
